Quote Originally Posted by Tergon View Post
The system froze after 5.3 minutes, hard lock forced hardware reboot. Will have to tweak a few more settings any suggestions or if you need info to tell let me know. Had to enable Swap file to get the program to run, I hate swap files.
You can probably get around the swap issue by enabling diagnostic startup using MSCONFIG.

I think Andreezy is spot on, you probably do not have enough vCore. 1.38v is very low for 4.4GHz... A bit more volts there would most likely do you good.

With 12GB Ram, 1.25v QPI also seems low to me... Generally the rule I've been following is set QPI to 1.35v and then see how high your UCLK can go.

For 143 BCLK, you don't need to increase PCIE speed, 100 should be fine.

Lastly, your IOH is high. I use 1.2v IOH for 200BCLK with 2x GTX560 Ti's in SLI.