MA790X / MA790XT-UD4P 790X bugs fixes etc etc.....

[AmdAtiTom420]

Since you've overclocked the wattage has gone up...the wattage only applies to the stock frequency. I see you've unlocked L3 as well... for example that CPU might have been an Athlon because it didn't meet TDP...take out cache, lower voltage, lower frequency and you have yourself a 95w 630.

If my TDP went up, my temps would not be so low. Idle = 30-33C, Load = 45C running Hyper Pi 32M. eg.. my friend runs his 125w PII x4 920 at stock, 2.8ghz 1.35v, with idle temps 7-10C higher than mine.

Or they may have lowerd the TDP(and clock speeds) and disabled the L3 cache to meet market demand and/or to keep the market from being flooded with PII x4's.

[BeepBeep2]

If my TDP went up, my temps would not be so low. Idle = 30-33C, Load = 45C running Hyper Pi 32M. eg.. my friend runs his 125w PII x4 920 at stock, 2.8ghz 1.35v, with idle temps 7-10C higher than mine.

Or they may have lowerd the TDP(and clock speeds) and disabled the L3 cache to meet market demand and/or to keep the market from being flooded with PII x4's.

Temp sensors vary as well as heat from chip to chip.

Stock cooler?

My 565 idles at 17c? in a 20c room, but my 965BE idles at 31 if that tells you anything.

Different mounts, IHS flatness, etc...have lots of effect on temps. When your CPU runs faster, it uses more power. It's as simple as that...adding voltage also ups TDP.

[AmdAtiTom420]

Temp sensors vary as well as heat from chip to chip.

Stock cooler?

My 565 idles at 17c? in a 20c room, but my 965BE idles at 31 if that tells you anything.

Different mounts, IHS flatness, etc...have lots of effect on temps. When your CPU runs faster, it uses more power. It's as simple as that...adding voltage also ups TDP.

Yep.. stock Phenom II cooler and AS5

[Hell Hound]

Whats the measurement of the pinhole to pinhole for the mosfet on the ddr2 ud4p?
Who is using a water block for the mosfets on this board?
Has anyone passed 300HT w/1100T 24/7 STABLE?