Quote Originally Posted by recent View Post
This build is amazing ! read the whole thread. I want to start building my own WC loop.
But have a noob Question :

Why the fans on your rad, blow away from the rad not into the rad ? and why are they tick not fat fans ?
thanks
there are few possible configurations - you can install fans so that they blow (or push) air into the rad, then fans can pull air out of the rad (like I did) and the most powerfull combo - 3 fans on each side, this one called push-pull Pull configuration gives slightly better results in this particular setup, moreover I have fans in the door that push air inside

I just don't have space for thick fans, also I dunno if there are thick 140mm fans

Quote Originally Posted by Biffa View Post
Just finished my latest build using the same technique for the rad mount in the PC-P80.

No where near as elegantly done as this one, though. Great job so far.
thanks, Biffa, glad you like it

Quote Originally Posted by ColdzeroTeam View Post
i've have some "problems" with the pk-3 as well. they made a strange noise in the beggining, but i let them roll for a while and the noise was gone afterwards.
i wouldn't use yate loons, at least the 120mm version as they make a very annoying bearing noise that can be heard miles away. (Sleeve bearing version at least)
140mm YLs are surprisingly good in terms of noise, I can't hear any annoying noise they are on par with PK3s when it goes to the sound