***Asus Rampage III Extreme Owners Thread***

[tistou77]

I'm lost with all these bios available (901, 0878, 0010, etc ...)

I noticed that in the bios 0010, there are fewer options compared to 0878 for example

which it is advisable to use?

thank you very much

[AceBaran]

I'm lost with all these bios available (901, 0878, 0010, etc ...)

I noticed that in the bios 0010, there are fewer options compared to 0878 for example

which it is advisable to use?

thank you very much

What he said !

[rhia]

Hi guys, great thread, learnt a lot from it

Over the weekend I added a ek-fb re3 waterblock and a Silverstone Strider 1500w psu to my system.

However, I now cannot overclock my system at all, when I change the Ai Overclock Tuner from Auto to Manual and exit the bios, the motherboard gives me the post beep as normal, power to my peripherals (keyboard, mouse etc) but no signal is sent to my monitors.
The only way I can get the motherboard to post properly is to clear the cmos, and everything works correctly at stock settings.

Previously I was running my I7 920 at 4GHz, 1.35V on the Vcore/QPI, 1.2 IOH, never tried anything extreme or out of the ordinary.
CPU is at 35-40oC and NB at 30-35oC, even so I put back the stock heatsink, but the problem remains.
The problem occurs on both bios chips (bios1 = 0802, bios2 = 0901), and when I set voltages manually.

Any help or advice would be extremely helpful,
Many thanks,
Rhia

[kurumi_Japan]

Hi guys, great thread, learnt a lot from it

Over the weekend I added a ek-fb re3 waterblock and a Silverstone Strider 1500w psu to my system.

However, I now cannot overclock my system at all, when I change the Ai Overclock Tuner from Auto to Manual and exit the bios, the motherboard gives me the post beep as normal, power to my peripherals (keyboard, mouse etc) but no signal is sent to my monitors.
The only way I can get the motherboard to post properly is to clear the cmos, and everything works correctly at stock settings.

Previously I was running my I7 920 at 4GHz, 1.35V on the Vcore/QPI, 1.2 IOH, never tried anything extreme or out of the ordinary.
CPU is at 35-40oC and NB at 30-35oC, even so I put back the stock heatsink, but the problem remains.
The problem occurs on both bios chips (bios1 = 0802, bios2 = 0901), and when I set voltages manually.

Any help or advice would be extremely helpful,
Many thanks,
Rhia

If default setting has no problem, I think you set wrong voltage or other setting.
The 1st, only change Vcore voltage rest of all set default.
If you can not boot, CPU may corrupt.
Uncore block has some damage, it does not accept any BIOS changes.


Sorry for my bad english.

[AceBaran]

I'm lost with all these bios available (901, 0878, 0010, etc ...)

I noticed that in the bios 0010, there are fewer options compared to 0878 for example

which it is advisable to use?

thank you very much

I just got my board last week and it had 0910 installed.. so that is the only bios i have seen so far !! cant compare ..