Rotary Fitting leaking!! Suggestions needed.

[Fatfool]

I've had BP fittings leak personally when there was tension on the line. That said, they are pretty solid when there isn't a lot of force on them. Currently I'm using enzo 45 rotaries and they are rock solid also... On your gpu block can you switch the plug to the other side and use regular compressions.

ah. Well, i didn't put much force on mine too and it still seeped out. what a bummer.

45 degree enzos? Too bad they don't have 1/4" love. But i'd be willing to try the 90 degree enzos even though they're not compressions and they look silly. build quality looks decent. Do they wobble around when pushed? How's it secured? I mostly have experience with compressions only. DO you cable tie them?

as for switching it over, that's a no go. The fan sits directly above both fittings. tried the straight compression barb. No go. not even with 1/4" tubing. Seen any 45 degree 1/4" rotaries around?


btw, I must note that the most secure rotary in my loop happens to be my 1/2" ID, 3/4" OD one.

http://www.specialtech.co.uk/spshop/...at=1619&page=1


Bizarrely, It's an el cheapo no name, roughly finished, industrial looking one that does the job surprisingly well. That rotary is under a hella lot of stress yet doesn't budge at all. oh my..... they don't have the 1/4" version though darn... I'd get a handful of them.