MMM
Results 1 to 25 of 65

Thread: Rotary Fitting leaking!! Suggestions needed.

Threaded View

  1. 04-13-2010, 10:29 AM #21
    Orangey
    Orangey is offline
    Registered User
    Join Date
    Jan 2010
    Location
    Uck
    Posts
    40
    On my GPU block (EK 5850) you must use a spacer or a fitting with a stubby thread on the copper side. The reason being that the thread on that side is shorter. Maybe someone can expand on this, I'm not exactly an expert.

    I don't know if this helps but thought I would mention it as my block was leaking in the exact same place until I used a spacer.

    As far as replacements go, a (Bitspower) "cube" elbow fitting might be small enough even when combined with a mini dual-male G1/4" adaptor.
    Last edited by Orangey; 04-13-2010 at 10:36 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules