Quote Originally Posted by Hoss331 View Post
Is that done with the USB3? On my UD3P the only bios that would allow me to drop down to PL7 on 3.20B and cas 6 was F1 and that was hit or miss. Sometimes it would drop down fine and would prime other times not even able to be set, bandwidth was alot better though but not stable enough to use.
Yes, it's the USB3P; incidentally, the bios is also F1. I find that TRCD is the most important setting for stability. Mine won't even post with a TRCD of 6 @ 1600 no matter the TRD setting (1600 CAS 8 Ripjaws here); 6-6-6 is a no go, 6-7-6 is good, but 6-8-6 or even 6-8-7 is better. So generally, TRCD should be equal or 1 unit higher than TRD or two units higher than CAS in some instances if you want to wring every bit of performance from your kits. This is true for the ECOs too.

Quote Originally Posted by DTV DRAGON View Post
thanx ive always wondered about the secondary timmings Iam still fairly new to o/cing with this board, but so far I love it, alot more stable than the uld3r was I will recheck my ram timmings on next boot as well rais up my fsb more as this board is running cooler as well
No problem. For even better stability, you can set TRFC to 88. It doesn't hurt performance.