Gigabyte EX58-UD5/Extreme Discussion Thread

[4Qman]

Can somebody check the below settings are for 4ghz. I try x20 and I get BSOD, increased vcore and QPI but still BSOD.


Cooling is TRUE copper. At these settings below i am
IDLE: 37oc ISH
Load: Low 70's

At current 3.8ghz its been test 3hrs Linx and stable.

CPU voltage as using dynamic is:
Idle 1.040v
Load: 1.168v

CPU Clock Ratio [19x]
QPI Clock Ratio [X36]
BCLK [200]

Advanced CPU Features
Intel(R) Turbo Boost Tech [Disabled]
CPU Cores Enabled [All]
CPU Multi Threading [Enabled]
CPU Enhanced Halt (C1E) [Enabled]
C3/C6/C7 State Support [Enabled]
CPU Thermal Monitor [Disabled]
CPU EIST Function [Disabled]
Virtualization Technology [Enabled]
Bi-Directional PROCHOT [Enabled]

Uncore & QPI Features 
Uncore Clock Ratio [x16]
Isonchronous Support [Enabled]

Advanced Clock Control
Base Clock (BCLK) Control [Enabled]
PCI Express Frequency (MHz) [102]
C.I.A.2 [Disabled]

CPU Clock Drive [ 800mV]
PCI Express Clock Drive [ 900mV]
CPU Clock Skew [ 0ps]
IOH Clock Skew [ 0ps]

Performance Enhance [Standard]
Extreme Memory Profile (X.M.P.) [Disabled]
System Memory Multiplier (SPD) [x8]
DRAM Timing Selectable (sPD) [Quick]

CAS Latency Time 7
tRCD 7 
tRP 7
tRAS 21 
CMD 2

Advanced DRAM Features:
Performance Enhance [Standard]
Channel Interleaving [Auto]
Rank Interleaving [Auto]

Load Line Calibration [Enabled]
CPU Vcore [Normal]
QPI/Vtt Voltage [1.240V]
IOH Core [Auto]
DRAM Voltage [1.640V]

Advanced Voltage Control 
Dynamic Vcore [+0.08750v]
CPU PLL 1.800v [1.800v]


PCIE 1.500v [Auto]
QPI PLL 1.100v [Auto]
IOH Core 1.100v [Auto]
ICH I/O 1.500v [Auto]
ICH Core 1.1v [Auto]

DRAM Voltage 1.500v [1.50V]
DRAM Termination 0.750v [AUTO]
Ch-A Data VRef. 0.750v [AUTO]
Ch-B Data VRef. 0.750v [AUTO]
Ch-C Data VRef. 0.750v [AUTO]
Ch-A Address VRef. 0.750v [AUTO]
Ch-B Address VRef. 0.750v [AUTO]
Ch-C Address VRef. 0.750v [AUTO]