Thermochill Compression Fitting Preview

[bentleya]

durability? very thin wall compared to others.

They very solid and personally i can't see any problem with durability. As on a side note, the retention nut screwed down better on the Thermochill Fitting followed by the Bitspower. However the Primochill and TFC both jam up and are not smooth to screw down.

So many nice photos and not a single one with the collar off? Would have liked to see the flare on the barb itself.

Give us a few hours and i'll get some uploaded .

Hopes for 3/8"ID.

Cheap with hex-nut. Brilliant.

I'll said an email out to Thermochill in the morning, to see if, A) What other sizes will be made, B) When they will be come available to buy in the states and the rest of Europe.

http://www.xtremesystems.org/forums/...06&postcount=2

Thanks, Truly one of the best threads on XS .

It's interesting (and sad) to me that they can't seem to ship near enough rads but they're working on other products. Can we get some pa rads in the states? How about some shrouds? Can they make a shroud for the 120.4? (or if they already have can you get it to resellers?)

WOW Thermochill, use one production facility for the rads and a different for the fittings. The rads are made in a small UK Factory and are turning out as many as they possibly Can.

The 140.3 has had a shroud for a long time. I think your'll be best to get in touch with Thermochill via the contact section on they website. As i'm sure they will answer it better than i did and can.