Okay, Okay ... guilted into getting off my lazy behind (and Wezly twisted the knife in my back) - took the case out of the box.

Cut my old midplate to provide some support for the new plate. Spared you the pics of that. Here's the case, ready for mocking up the loop and PSU cabling layout:






Wanted to make sure the tubing was relatively straight from the top radiator to the mid-plate. A little adjustment, and it should be fine:





And, because it's been so long, an artsy shot - shows the rivets are going in okay.





Tasks for tomorrow - finish up the loop and PSU cabling mock ups.