** Official ** Gigabyte UD3 P45 Series -- EP45-UD3 / EP45-UD3R / EP45-UD3P

[MarkJohnson]

I have my E5300 at almost 4GHz (13 x 305MHz). I was hoping someone can give me advice on getting a little more out of my E5200?

My BIOS Settings:

*** GigaByte GA-EP45-UD3R BIOS F9 ***
Robust Graphics Booster: Auto
Cpu Clock Ratio: 13.0

*** Clock Chip Control ***
CPU  Host Clock Control: Enabled
CPU Host Frequency(MHz): 305
PCI Express Frequency(MHz): 100
C.I.A.2: Disabled

*** Advanced Clock Control ***
CPU Clock Drive: 800mV
PCI Express Clock Drive: 900mV
CPU Clock Skew: 0ps
MCH Clock Skew: 0ps

*** DRAM Performance Mode ***
Performance Enhance: Turbo
(G)MCH Frequency Latch: 266MHz
System Memory Multiplier (spd): Auto
DRAM Timing Selectable (spd): Manual
*** Standard Timing Control ***
CAS Latency Time: 6
tRCD: 6
tRP: 6
tRAS: 18

*** Advanced Timing Control ***
tRRD: Auto
tWTR: Auto
Twr: Auto
tRFC: Auto
tRTP: Auto
Command Rate (CMD): Auto

>>>Channel A: All Auto
>>>Channel B: All Auto

*** Motherboard Voltage Control ***
>>>CPU
Load-Line Calibration: Disabled
CPU Vcore: 1.34375V
CPU Termination: 1.3600
CPU PLL: 1.500V
CPU Reference: Auto
>>>MCH/ICH
MCH Core: 1.400V
MCH Reference: Auto
MCH/DRAM Reference: Auto
ICH I/O: Auto
ICH Core: Auto
>>>DRAM
DRAM Voltage: 2.220
DRAM Termination: Auto
Channel A Reference: Auto
Channel B Reference: Auto

*** Advanced BIOS Features ***
C1E: Enabled
EIST: Enabled

This rig:
GigaByte GA-EP45-UD3R BIOS:F9 (Is there a better BIOS for OC?)
E5200 2.6GHz@3.96GHz (50% OC)
4GB (2 x 2GB) OCZ Flex 6-6-6-18@2.2V (OCZ2FXE1200GK) on air
850Watt Antec Quattro PSU (TPQ-850)
CPU Temps: 60C-65C under LinX - Water cooled CPU.

Thanks for any help
-=Mark=-