Originally Posted by
The Viper
Man thats awesome, I just tried to squeeze 1188 out of my RAM, and I get errors in memtest86 no matter what I change.
I just stopped Prime95 from testing. I ran 7 hours with no errors and tested intelburntest stable as well before I started that. These are my settings.
Code:
Robust Graphics Booster - Auto
CPU Clock Ratio - 8 X
Fine CPU Clock Ratio: +0.5
CPU Host Frequency - 495
PCI Express Frquency - 100
C.I.A.2 - Disabled
****Advancded Clock Controll****
CPU Clock Drive - 1000mV
PCI Express Clock Drive 1000mV
Clock skews are all set to 0PS.
****DRAM Performance Control****
Performance Enhance - Turbo
Extreme Memory Profile - Disabled
(G) MCH Frequency Latch - 333MHz
System Memory Multiplier - 2.40B
Dram Speed: 1188MHz
DRAM Timing Selectable - Manual
>>>Sandard Timing Control<<<
CAS Latency Time - 5
tRCD - 5
tRP - 5
tRAS - 15
>>>Advanced Timing Control<<<
PL : 8 On both channels
DDR Write Training : Off for both channels
Everything else is Auto.
Driving Strength Profile - Auto
****Motherboard Voltage Control****
>>>>CPU
Load Line Calibration - Enabled
CPU Vcore - 1.350V
CPU Termination - 1.42V
CPU PLL - 1.590V
CPU Reference - .884V
>>>>MCH/ICH
MCH Core - 1.520V
MCH Reference - .899V
MCH/DRAM Reference - 1.000V
ICH I/O - 1.500V
ICH Core - 1.100V
>>>DRAM
DRAM Voltage - 2.100V
DRAM Termination - .800
Channel A Reference - Auto
Channel B Reference - Auto
CPU Features are all Disabled.
If I set my FSB Term any higher then 1.42 it errors out, or it is the NB voltage if I go over 1.52 one of the two. All I know is that it is stable as a rock here. These are the settings I was using for 490 x 8.5 as well I will add.
@Rubber
What cooling method are you using air? If so what cooler? Try my settings listed above maybe, if your cooling can handle it.
Reply With Quote
Bookmarks