Just spent all night reading this thread from start to finish!

Just designing myself a new system, which will go into a MM Ascension case, everything is sorted except for the front panel, the style of which hinges on how I will change my loops and their requirements.

Currently I run 2 separate loops.

#1 Micro res -> 655 -> 360 Fessler -> HK 3.0 (i7 975) ->BP VREG ->BP NB
Planning on adding a Fessler 240 between HK 3.0 & VREG n 1/2"

#2 Micro res -> 655-B -> 240 Fessler -> 2x285 GTW (Original) with EVGA HC blocks on 3/8"
Planning on upgrading to 360 Fessler

I have my rads with shrouds in a pull config. I have the EK tops on both my pumps.

The T3 looks and sounds good, but with this set-up would I be better with 2 rather than just one?

Heat is a big issue for me, I live in S. Florida so anything to drop my temps is a plus!

Fluid is something that is worrying me, I used to use Primochill, but I added one of their dye bombs and it clogged up my system, it separated from the fluid and basically sent a 360 rad to the trash. I've used Fessler ever since.

Currently I am considering the T3, changing pumps and going with the XSPC dual or getting the EK res's with the waterfall.

Unless I am mistaken, the T3 seems to improve flow rate, but how much - if at all - does it improve temps?