i could use some tips from the experts who played with everything.

i use just normal barbs that comes with my blocks, or the ones i had to instal into my heatercores, and i clamp them with normal worm gear clamps. however with the T3 i dont think i can really reach in there from a side angle to screw in the worm gears, (but honestly i can if i need too, its not that bad). i just dont like the clamps that came with the T3, i had leaking issues cause they were loosened up a little, and i so i just used vice grips to lightly grab the plastic fittings and tighten until i was comfortable.

im thinking i will be taking off the outside clamp of the T3 standard clamps and use my own worm gears, or unless you guys can recommend me something else (i really dont know what else is out there). but the goal is something that will not leak and easy to install and work with (the T3 ones really twisted up my tubes and i had to put them in first or have fun spinning the tubs on the other side of the line)