Hi there

I recently changed from a Q6600 G0 to a QX9650 .
Actually itīs running on 420x9.5 which gets me near the rated speed of my oczīs 1000 cl5 and near 4ghz cpu clock.
Memory and FSB settings will stay as they are until i get my preordered OCZ Blades 1200īs which I hopefully can run @ 1200 and 450 fsb

With the QX i have a strange problem which I found that I am not the only one who gets this with a asus x48/x38 board and a QX with a used cpu multiplier other than 9
System boot up from cold (cut off from the voltage with a socket switch) i get a message after POST that the VID setting or something like that is invalid ad Iīve to enter bios.
Done that, cachanged nothing, exit bios, system boots, perfectly stable.
I can restart as often as I want, it will allways boot up normally, except i take the system completly off Power with the socket switch or the switch on the PSU.

One other thing I found to be an issue for me is voltage and Temp measurement.
When I use the program "Hardware monitor" there are listed 2 winbond chips with provide information on System voltages and temperatured.
Time after time, one of the 2 disappeares from the program.
The same happens when I use the Vista Sidebar gadged from Everrest, that time after time most Cpu Relevant Voltages drop to zero, including NB Temp.
I had this issue yesterday while running prime small
A restart of Everrest ended in the fact that the values which just went to zero, werent even shown as avaliable.
I really have no clue what the reason is for that kind of issue or problem. NB Temps where less 50°C while that happened.
After a reboot of the system the previously missing Values were avaliable again.

Ideas ?