Asus P6T Deluxe Discussion Thread

[Burner27]

Hello everyone. I have the first version of this board. Yesterday I wanted to reset the bios via cmos jumper however I accidentally removed the jumper of the chassis intrusion pins. And when I realized it I put it back. Since then I can't boot my pc. After cpu, ram and hdd recognition it writes " Chassis Intruded! Fatal Error ... System Halted" and everything freezes. I tried to reset bios via jumper and by removing the bios battery. I waited 12 hours without battery but nothing changed. I upgraded the bios with EZFlash to 1504 but still I get the same error message. If I reset bios then I can go into bios with F1 key. After arranging the bios and saving I can't boot, same message appears on the screen. I can't continue with F2 after bios reset because my disks are in AHCI mod and windows can't load because when I reset the bios all the disks begin in IDE mode. Anyway did you have a similar problem? Or know about this problem. I'd really appreciate any help. Otherwise I would go for an RMA. Thanks.

For laughs I decided to do what you did initially and was able to replicate your issue. I followed the instructions in the manual and I unplugged the cord to the PSU, moved the CMOS Clear jumper over for 20 seconds, then moved it back, booted up and the issue is gone. Have you tried the setting in the BIOS that says "Load Setup Defaults"?

Also, try using a different jumper. Maybe the contacts aren't being made within the jumper. To be sure you put the jumper back correctly--you have the jumper over the two pins that are right next to each other--correct?