Thank you for your reply!
The setting strong or even stronger will make my system unstable. So I set it back to moderate.
The vDimm is 1,98v real and I think it could be lower.
I installed BarEdit vers. 3 and saved the bar text with a sreenshot below:
What am I supposed to do now?
@mikeyakame,
you have posted yesterday:
1T = whatever the base step degree value is necessary to give the calculated delay skew value at any one point in time. If MCH calculates 300ps dimm1, 360ps dimm2, 395ps dimm3, 455ps dimm4, then base step degree will be whatever the closest step selection is available which can be used for channel a clock fine delays for example. Step might be 90ps in this example as all 4 dimm flight delays will be pretty close to the calculation for x amount of degrees using that base step selection. 90ps @ 4 degrees gives 360ps, 90ps @ 5 degrees gives 450ps, 1T = 1 degree of base step
The slot 2 and 4 are occupied with one stick.
To get the timings about being even I should set 100ps advanced to the slot 2 that means dimm2 would have ~460ps and about as much as the dimm4 with 455ps.
Did I get you right or wrong?
Reply With Quote
Bookmarks