Ya, I'll be leaving the badge on, I'll support my Cooler Master, I like there products.

and booger, I like that info there about the fans. So Slow Speed fans work better in a Pull config, Faster fans work better in a push config, and medium fans like mine, it doesn't really matter.

So I'd be ok to just set them for push and have it go Case, fan, Rad then?

Also, this is my first loop ever. I have everything ready to go. I just need to do it. I have tomorrow off, and then thursday and friday. So tomorrow I want to put the case back together, and this is what I had planne.d Tell me what you all think. I was going to take an old motherboard and mount it inside my new HAF.. I'll then completely setup the Watercooling system where I "Think" I'll put it all, and then use an old 300w PSU to power on, and run the Pump. Then I'll leave everything in there, and the old Mobo. set it all up, and run a leak test from tomorrow, all through Wednesday. and if all goes well. Then Thursday I can go ahead and take apart my current system, and move everything over to the new HAF. and mount the Mobo into new case, and just hook up the CPU Block to it's spot. and everything else will be in place... Does this sound Ideal? and would that work ok? and when I do it, I'll just take into consideration the two 260's that will be in the middle, bottom of case, and I wont run any tubing there. Does this sound like an OK way to do this.

Also, does anyone have any suggestions on where to put the Res, I was thinking right in front of my 260's on the back end of the case, under the rear 120mm fan. but now I'm thinking I'll just put it in the bottom 5.25 drive bay instead?.. sound ok?

thanks