Quote Originally Posted by Lukee View Post
Ok, I think I found out the problem. I looked at the socket and I think some pins got bent. I didn't lay it flat when I changed out the CPU because of my reservoir, so when I tried closing the cpu socket, it must have bent a couple of pins because the CPU slid down a little.

Has that happened to anyone else? Can I bend it back or do I have to buy a new board?

Looks like I am going to have to buy a new board. I'm not going to RMA it because I'm sure when they see the pins it will give it away.

So, would you guy buy Gigabyte again? I really hate the long boot times.
I had the same problem and successfully RMA'd the board. The only difference was the computer ran fine for about 2 hours then started that reboot cycle. I have seen a few reviews on Newegg describing this issue and they all RMA'd. Good luck!