DFI LP UT X58-T3EH8 - First bench, bios screens etc

[eva2000]

Ah, i thought you already knew this, eva. I already have post this issue in DFI forum.
When i install Windows XP x64 (SP2) in my rig, everything is fine until i try shutdown or reset the system. Shutdown -> power on leads to 88 code, board dead. Reset leads to system hangs, FF code and blank screen. Only reset cmos with jumper or unplug and replug the PSU wire restore the system. The workaround that solve this problem is play with pcie roots settings.

Haven't experienced such issue before, had one that was close with shutdown overnight and power up next day = postcode 75 but that was due to incorrect memory settings/voltages when i load my default set profile from cmos reloaded. Overwrote my default saved profile which i usually reload with correct memory voltages/multiplier and no more probs.


care to share your bios settings via this template http://i4memory.com/f80/dfi-lp-ut-x5...emplate-12919/

same here, you need let it hang like that for 12-20 minutes or more it takes forever and then it flashes

Hope this is the solution, wil try tomorrow morning:

http://csd.dficlub.org/forum/showpos...&postcount=158

for 1/14 bios which has gone official more explanation of the problem and solution at http://i4memory.com/f80/dfi-ut-x58-t...eleased-13876/

where do you see the board revision? what about blank screen ? do you still get ?

right here - mine's R.A51

Only in SLi mode the blank screen problem appears to me, in Vista x64 SP1, solved with eva2000 memory lowgap advice. Sadly also got the laggy problem though i've never used abs... so i've followed the method described before, took battery out, flashed 09/01/14 bios, but the problem is still here.
I'll try tonight a clean install..

Flashed latest bios and reloaded ABS although i never use(d) profiles. There's stil a bit lag in 3D but only the first 20 ~ 30 seconds, after that its gone. Before it lagged all the time.

DVD that came with the board wont load, not in XP nor Vista. All other DVD's i tried are fine though...

Grinch i have 3x1GB 1866 Dominators and 3x1GB Ballistix with D9GTR and both sets run ok

Did both of you confirm after popping up the battery than when you booted back into bios all cmos reloaded slots were cleared before flashing bios ?

Strange about dvd-rom, are you guys running IDE or SATA DVD drives and do you have ACHI/RAID or IDE mode set ?

As for me, been doing some video encoding lately at comfortable 4009mhz at 1.328-1.344v and interesting results



testing new 01/14 and 01/20 beta bioses soon