Finally with Simps HowTo, I was able to make my Q9450 stable for 24/7 work. Now Prime95 is testing at home, so I will post screens later, but here are my settings:
Temp doesn't go over 65-66C and for now I'm pretty happy with it.Code:Processor: Q9450 Ai Overclock Tuner: Manual OC From CPU Level Up: Auto Ratio CMOS Setting: 8 FSB Frequency: 480 CPU Clock Skew: Auto (for now) NB Clock Skew: Auto (for now) FSB Strap to North Bridge: 333 DRAM Frequency: DDR2-960MHz DRAM CLK Skew on Channel A1: Auto (for now) DRAM CLK Skew on Channel A2: Auto (for now) DRAM CLK Skew on Channel B1: Auto (for now) DRAM CLK Skew on Channel B2: Auto (for now) DRAM Timing Control: Manual 1st Information: CAS# Latency: 5 DRAM Clocks DRAM RAS# to CAS# Delay: 5 DRAM Clocks DRAM RAS# Precharge: 5 DRAM Clocks DRAM RAS# Activate to Precharge: 15 DRAM Clocks RAS# to RAS# Delay: 3 Row Refresh Recycle Time: 55 DRAM Clocks Write Recovery Time: 6 Read to Precharge Time: 3 2nd Information: Read to Write Delay (S/D): Auto Write to Read Delay (S): Auto Write to Read Delay (D): Auto Read to Read Delay (S): Auto Read to Read Delay (D): Auto Write to Write Delay (S): Auto Write to Write Delay (D): Auto 3rd Information: Write to PRE Delay: Auto Read to PRE Delay: Auto PRE to PRE Delay: Auto All PRE to ACT Delay: Auto All PRE to REF Delay: Auto DRAM Static Read Control: Auto DRAM Read Training: Auto MEM. OC Charger: Auto Ai Clock Twister: Stronger Ai Transaction Booster: Manual Common Performance Level: 10 Pull-in of CHA PH1: Disabled Pull-in of CHA PH2: Disabled Pull-in of CHA PH3: Disabled Pull-in of CHB PH1: Disabled Pull-in of CHB PH2: Disabled Pull-in of CHB PH3: Disabled PCIE Frequency: 101 CPU Voltage: 1.250 CPU PLL Voltage: 1.55 FSB Termination Voltage: 1.36 DRAM Voltage: 2.19 North Bridge Voltage: 1.45 South Bridge 1.5 Voltage: 1.50 South Bridge 1.1 Voltage: 1.10 CPU GTL Reference (0): -55mv CPU GTL Reference (1): -10mv CPU GTL Reference (2): -55mv CPU GTL Reference (3): -10mv NB GTL Reference: +60mv DDR2 ChA Reference Voltage: +12.5 DDR2 ChB Reference Voltage: +12.5 North Bridge DDR Reference: -25 CPU Configuration: Ratio CMOS Setting: 8 C1E Support: Disabled Max CPUID Value Limit: Disabled Intel Virtualization Tech: Disabled CPU TM Function: Disabled Execute Disable Bit: Disabled Load-Line Calibration: Enabled CPU Spread Spectrum: Disabled PCIE Spread Spectrum: Disabled
Unfortunatelly my memory doesn't boot at lower PL, no matter what I do. It just freez on DET_RAM and doesn't show boot screen at all.
And a question to Simps - how do you set GTL's to 00 ??? I don't have 00 as an option ?
Reply With Quote
Bookmarks