Quote Originally Posted by CryptiK View Post
Did a bit more testing.

Orthos custom run 4096K
vcore 1.263/1.268 - 1.272 (idle/load)
vNB 1.20v
PL8

When I ran linpack it was not quite stable so increased vNB one notch, which gave me stability.
Looking good CryptiK.

Here is what I have found it is best and takes less time to test a system for full stability.
I found out that you only need to run IBT and PRIME BLEND.
I start with IBT 20 loops on max stress. If it don't pass it, then I don't even bother with PRIME. If it passes, then I go for prime blend for 4 hours.
If it passes, its done.

I have never had a single setting that passed 20 loops IBT on max stress, and 4hours prime blend to crash on me. All the other stress programs like OCCT, PRIME SMALL FFT's, memtest, etc, will pass too.

[]'s
Simps