Ok so trying to push the boundaries here a little – see below.
Trying to figure out if I can get 4.2 HT on - prime and linpack stable.
So, on air - linpack passed 5 runs but at an outrages temp of 100C about 10 times in quick hits– it is a wonder it did not blue screen or restart
I also ran prime for 5 minutes just for comparison – max temp was 90C, a full 10 degrees less!
So I don’t think this is a doable do on air but I think a good water setup might have a chance on this proc? Your thoughts?
Reply With Quote
Bookmarks