Quote Originally Posted by BuGjAE View Post
@Ghostleader Do you try strap 400 yet? I cannot boot up 333 strap with high FSB And I always use High Fsb
Hmmm strap 400, if I set Mem Multi to Auto with Latch 400 it show 1200 but it is no go.

With Latch 400 I can set 2,00D (1000), 2,66D (1333) and 3,33D (1667).

I can boot in to Windows and do a 1M SuperPi with 500 4000 1333 555 15 tRD 8 Turbo, this one was no go with MCH Core 1,40 but with 1,30 hmmm (shall do more test later with this setup).

Can run 1333 but not 1200, go figure ???????????????




Quote Originally Posted by pangingIII View Post
[IMG]Ghostleader,

try the above voltage setting in your BIOS, i just booted with this setting and run a few quick system tests as you see in the pic.

to see if you can get a stable system with the voltage setting, if so, and with 2x1GB RAM, you can try lower MCH core and CPU termination voltages,
and then retest your overclock again, i would say MCH core 1.30-1.36v, CPU termination 1.20-1.30v, also try MCH ref. value 0.68v and maybe 0.72v (of VTT 1.20v),
for memory timings, you may want to first try setting Auto, and if you set Turbo, the board's bios will enter SPD's (usually, it will be using timing of the module when running at DDR2-800) timings and this should work ok with a good overclocking ram kit like yours.

i hope this helps.


-----------------
note-- in order to use the ET6's voltage setting value in your BIOS, for example, if you want to try my voltage setting (above),
the easy way is to first set VTT to 1.20v, Vdimm 1.80v,
and then set the other voltage and ref. settings using the value shown in the ET6 and go back to VTT and Vdimm and change the 2 values last.
----------------------------------
First I most say, awesome pangingIII, you should have all respect for your help, even on Christmas eve, I donīt have words.


but, sorry, no boot with that setup, it try to boot 2 or 3 time then boot up with some fail safe setup, same as with my setup, (not much of a different between yours and mine setup)

I donīt understand this, whatīs wrong.

Well I tried some with FSB 550 and so far so good.