Hello ppll!

After some weeks of test to get my settings prime aproved i can only do Small ffts 15mts and sometimes more... but i cant get my Volts lower than this need your help!!!

Q9550 Asus P5Q3 DLx Gskill 2x 2gb DDR3 1333 CL7

CPU Ratio Setting: 8.5
FSB Frequency: 475
PCIE Frequency: 100
FSB Strap To North Bridge: AUTO
DRAM Frequency: 1584 !!!!
DRAM CLK Skew on Channel A1: Auto
DRAM CLK Skew on Channel A2: Auto
DRAM CLK Skew on Channel B1: Auto
DRAM CLK Skew on Channel B2: Auto
DRAM Timing Control: Manual !!!!

CAS Latency: 7
DRAM RAS to CAS Delay: 7
DRAM RAS Precharge: 7
DRAM RAS Activate to Precharge: 18
RAS TO RAS Delay: 6
Row Refresh Cycle Time: 60
Write Recovery Time: 10
Read To Precharge Time: 6
Read to Write Delay: Auto
Write to Read (s): 6
Write to Read (d): 6
Read to Read (s): Auto
Read to Read (d): Auto
Write to Write(s): Auto
Write to Write(d): Auto
Write to Pre Delay: Auto
Read to Pre Delay: 6
Pre to Pre Delay: Auto
All Pre to Act Delay: Auto
All Pre to REF Delay: Auto
DRAM Static Read Control: Disabled
DRAM Dynamic Write Control: Disabled
DRAM Read Training: Disabled
DRAM Write Training: Disabled
MEM OC Charger: DISABLE
Ai Clock Twister: auto
AI Transaction Booster: AUTO

CPU Voltage: 1.40
CPU GTL Voltage Reference (0/2): Auto
CPU GTL Voltage Reference (1/3): Auto
CPU PLL Voltage: 1.70
FSB Termination Voltage: 1.36
DRAM Voltage: 1.94
NB Voltage: 1.32
NB GTL Voltage: Auto
SB Voltage: 1.20
PCIE SATA Voltage: 1.60

Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew: AUTO
NB Clock Skew: AUTO

Before i get to other values i want to get Prime Stable on this.

Any input helps! tks!

vox