Hello everybody

I just got a 2X2gb kit of corsair dominators 1066MHz and now my system feels flaky. Right now Im running them at 950MHz because the other speed I can choose with 333 strap is 1140MHz. Ill get the board to boot with mem@1140MHz but it will fail prime within seconds, intelburn test will also fail. Any ideas of how to get everything stable? Should I give up on 4GHz? stable? Thank you all for a very good forum.


Heres my current settings



CPU Ratio Setting: 8
FSB Strap to NB: 333
FSB Freq: 475
PCIE Freq: 105
DRAM Freq: 951
DRAM Command Rate : 2T
DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 12
RAS# to RAS# Delay : 3
Row Refresh Cycle Time : 55
Write Recovery Time : 6
Read to Precharge Time : 3

Read to Write Delay (S/D) : 8
Write to Read Delay (S) : 3
Write to Read Delay (D) : 5
Read to Read Delay (S) : 4
Read to Read Delay (D) : 6
Write to Write Delay (S) : 4
Write to Write Delay (D) : 6

Write to PRE Delay : 14
Read to PRE Delay : 5
PRE to PRE Delay : 1
ALL PRE to ACT Delay : 5
ALL PRE to REF Delay : 5

DRAM Static Read Control: Auto
Dram Read Training : Auto
MEM OC Charger : Enabled
Ai Clock Twister : Lighter
Transaction Booster : Manual

Common Performance Level [10]

Pull-In of CHA PH1 Disabled
Pull-In of CHA PH2 Disabled
Pull-In of CHA PH3 Disabled
Pull-In of CHA PH4 Disabled
Pull-In of CHA PH5 Disabled
Pull-In of CHB PH1 Disabled
Pull-In of CHB PH2 Disabled
Pull-In of CHB PH3 Disabled
Pull-In of CHB PH4 Disabled
Pull-In of CHB PH5 Disabled


CPU volt:1.32500
CPU PLL Voltage: 1.52650
NB Voltage: 1.35175
DRAM Voltage: 2.17100
FSB Termination Voltage: 1.31200
SB Voltage: 1.1
SB 1.5 Voltage: 1.5

CPU GTL Reference 0 : +20mv
CPU GTL Reference 1 : +20mv
CPU GTL Reference 2 : +20mv
CPU GTL Reference 3 : +20mv
North Bridge GTL Reference : AUTO
DDR2 Channel A REF Voltage : AUTO
DDR2 Channel B REF Voltage : AUTO
North Bridge DDR Reference : AUTO

Load Line Calabration : Enabled
CPU Sread Spectrum : Disabled
PCIE Spread Spectrum : Disabled