Quote Originally Posted by radaja View Post
@cryptik ive never seen the nb temps go above 35c.also do you think any of my issues could have to do with my power supply? its an antec basiq 550W w/ three 12v rails two are 22a and one is 25a.
That PSU should have enough power for your system, unless it's getting old and/or failing. Your 12v rail is low however, at 11.82v. If you can borrow one from a mate to test with it wouldn't hurt to rule it out. Upping the vNB though isn't going to really pull much more power, it's more the cpu pulling the most power. At a low cpu clock, can you run higher vNB without problems?

Quote Originally Posted by unex|st View Post
Anyone noticed multiplier issues when powering on from power off state? My board keeps starting up with 9x multiplier even if it is set at 8x. After applying a reboot the multiplier is set correctly (1307 bios and E6600 conroe)
Do you mean being unplugged from the power point or just a normal cold boot? I haven't noticed this from either situation but I use the 9x multi 24/7.

Quote Originally Posted by BuGjAE View Post
Radaja ,So Can you get pass Prime95 over 35 minutes with your setting?
For me I can't get pass above 35 minutes and constant FATAL ERROR around 31 minutes of "Blend" both Prime 95 and ORTHOS
but I'm pretty sure my Vcore is enough.

anyone have a suggestion? ThanX in advance.
Definitely lower you vPLL to 1.50v to start with, and try to stay below 1.6v no matter what. Also you may either need more vdimm (depends on your ram) or more vcore and vNB.