Live MB OC Report :: ASUS Rampage Extreme

[trfnj74]

I also had random BSOD and a couple of RSOD using Vista 64. I did update all drivers for all hardware and it still did it. Moved ram in to other slot also the video card and it still would happen. I was so pissed so I tried to load Vista 32 and not a single BSOD. I am researching this to firgure out why this is happened so untill then Ill run Vista 32.

I need some help here.

Having random BSOD and lockup issues and can't figure out what it is yet.

It will happen while gaming, but also when idle. It even happened while running Memtest86+ (which leads me to believe it's not a Windows issue)

When it happens while I'm in Windows, I get some horrible static and ticking coming out of my speakers (headphones). It also happened during a run of Orthos Blend the other night, which ended up waking me up in the middle of the damn night

This is a fresh install of the OS with all the drivers installed and up-to-date.

Here are my settings
CPU Type: E8600
Cooling: Stock
Bios version: 0501
OS: Vista Ultimate 64bit
Graphics card(s): 3870 X2
Memory Brand and speed: OCZ Gold 1600GHz

Tweaker Menu
Ai Overclock Tuner: Manual
OC From CPU Level Up: Auto
OC From Memory Level Up: Auto
FSB Frequency: 400
CPU Ratio Setting: 8
CPU Clock Skew: Auto
NB Clock Skew Auto
FSB Strap to North Bridge: 400
PCIE Frequency: 100
DRAM Frequency: 1600
DRAM Command Rate: 2N
DRAM Timing Control: Manual
1st Information:
CAS# Latency: 8
RAS# to CAS# Delay: 8
RAS# Pre Time: 8
RAS# ACT Time: 24
RAS# To RAS# Delay: 5
REF Cycle Time: 72
WRITE Recovery Time: 12
READ to Pre Time: 6
2nd Information:
READ to WRITE Delay (S/D): 10
WRITE to READ Delay (S): 6
WRITE to READ Delay (D): 8
READ to READ (S): 6
READ to READ (D): 8
WRITE to WRITE (S): 6
WRITE to WRITE (D): 10
3RD Information:
WRITE to PRE Delay: 24
READ to PRE Delay: 8
PRE to PRE Delay: 1
ALL PRE to ACT Delay: 10
ALL PRE to REF Delay: 10
DRAM Static Read Control: Disabled
DRAM Dynamic Write Control: Auto

Ai Clock Twister: Moderate
Ai Transaction Booster: Manual (PL-6 NO Pull-Ins)
EPU II Phase Control: Auto
CPU Voltage: 1.212
Load-Line Calibration: Enabled
CPU PLL Voltage: 1.51106
FSB Termination Voltage:1.15316
CPU GTLVerf (0): Auto
CPU GTLVerf (1): Auto
CPU GTLVerf (2): Auto
CPU GTLVerf (3): Auto
NB GTLVerf: Auto
North Bridge Voltage: 1.45797
DRAM Voltage: 1.90856
NB DDRVref: Auto
DDR3 ChannelA Vref: Auto
DDR3 ChannelB Vref: Auto
South Bridge 1.5 Voltage: 1.51106
South Bridge 1.05 Voltage: 1.06039
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled