1month+HEhee+ Brutal 1.56volts+ CPUvid/NBvid on 9x50 using Water/ High end Air

[justapost]

Yes with explanation,,CPU//RAM Prime Stable ... I have is the Origanal TA770 and Not 9950 OVERCLOCKING friendly at high of Freqencies...I made this work and i knew i would max My PWM's . The Most Ive primed has been 6hours @ 1.56volts 3450//2680nb//5300ht.. That seemed to be the Mobos sweetspot .. The One that breaks the camels back is when i aproach 3hours @3.5ghz but with lower NB/ht settings... PWMS work too hard and when they Start Sqeeling and sounding like bacon Frying i Stop prime I know ,, im not nice to my hardware hahaaa ..

He H had a similar situation with my first 9600BE in the DFI/Sapphire 790FX mobo at 2.9GHz. It required 2.4GHz nb to be stable and immediately froze with 2.2 or 2.0GHz. Longer testings however showed that this setup also was unstable it just failed prime later 3-4hrs instead of minutes.
You seem to use an PSU with more than 18A for the 12V rail, because otherwise your PSU should power off due too that limit been exceeded. On the M3A with an single 12V rail I found at 3GHz >1.45V the cpu pulled ~19W from the psu and powered of short after. May I ask what limit your PSU has for the 4pin 12V rail?

EDIT: You know you made me run prime95 with 3.2GHz/1.625V 2.4GHZ/1.5V for stability testing.