**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[Ace-a-Rue]

Hi all. Been a while since I visited this site but now I have a serious problem with my IP35 Pro. Everything was fine for many months until today. Just a simple restart and now the board hangs up on POST Code 26.

I have no clue what Code 26 means even from the manual.

I currently have the following hardware in my sig and like I said, everything worked for a very long time and all the sudden...poof. What can I do? I have tried CMOS reset a couple times but each time results in the same error. I have also tried each memoiry stick individually to no avail.

well, i managed to get a startup by removing the battery and resetting cmos. but once i get to bios and change my settings I get the error again.

any help is appreciated

look in you manual on page 5-2, it has three reasons...i would try disconnecting all your hardware to see if it will take you to looking for the boot coomnand...once you have that add your drive to see if it hangs..keep adding single pieces until you find what it is hanging on....my guess it is the DVD or hard drive.

do you have any raptor drives?...the Pro board has a problem with some models of the Raptor.