hi guys,

sorry to dig this up but i've got a small problem with one of these XSPC Laing DDC Top. It seems that one of the holes wasn't threaded properly and the screw goes in without any screwing motion for about half of its depth. As a result, that screw can't be tightened down fully and the corner has about say a 1mm gap.

Since the top is transparent, I took at look at the O ring and there is a lack of compression in the area. However, filling the chamber with water (from the tap of course; its not in the loop yet) shows no leakage. But I do profess that i do not know if the centrifugal forces of the pump if it's running could cause the liquid inside to be forced out.

Anyone had such a problem?
Can I use a regular tapping tool to retap that hole?

Thanks!