My E6600 with these settings failed Orthos Small FFT after 30 minutes. Advice?

Code:
JumperFree Configuration Settings
AI Overclock tuner: MANUAL
CPU Ratio Setting: 9
FSB Strap to North Bridge: 333
FSB Frequency: 378
PCI-E Frequency: 105
DRAM Frequency: 757
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: MANUAL

1st Information :

CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: AUTO
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

[2nd and 3rd information for RAM is ALL AUTO]

DRAM Static Read Control: Disabled
DRAM Read Training: AUTO
MEM. OC Charger: AUTO
AI Clock Twister: AUTO
AI Transaction Booster: AUTO

CPU Voltage: 1.5
CPU GTL Voltage Reference (0/2): .695
CPU GTL Voltage Reference (1/3): .695
CPU PLL Voltage: 1.58
FSB Termination Voltage: 1.26
DRAM Voltage: 1.96
NB Voltage: 1.2
NB GTL Reference: .665
SBridge Voltage: 1.10
PCIE SATA Voltage: 1.50

Load Line Calibration: ENABLED
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : AUTO
NB Clock Skew : AUTO
[In the 1201 BIOS, I have something here set to "Optimization"]

Advance CPU Settings
CPU Ratio Setting: 9
CPU VID: Default
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
Intel® Virtualization Tech: Disabled
CPU TM Function: Enabled
Execute Disable Bit: Enabled