Truth to be told I too was pretty pissed to TC after seeing there's a horrible load of the flux crap inside the rad. I did try to flush it out with gallons and gallons of cold and room and boiling water. It appears I didn't quite succeed as even today - 18 months later - the stuff is floating in my res...
:\
Bojamijams,
If you're a bit unsure about the soldering it can't hurt to poke some old boards&cards with the iron just to practice. Then few tips for the real deal:
If soldering on the small dot doesn't bag on the first time make sure the area cools down before retrying. Also, glue the wire on the board an inch back from the wire's end you're going to solder.
=)
Reply With Quote
Bookmarks