Quote Originally Posted by bigcesar View Post
oh thanks...

JumperFree Configuration Settings
AI Overclock tuner: MANUAL
CPU Ratio Setting: 8
FSB Strap to North Bridge: AUTO
FSB Frequency: 500
PCI-E Frequency: 101
DRAM Frequency: 1002
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: MANUAL

1st Information :

CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: 55
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

2nd Information :

READ to WRITE Delay (S/D): AUTO
Write to Read Delay (S): AUTO
WRITE to READ Delay (D): AUTO
READ to READ Delay (S): AUTO
READ to READ Delay (D): AUTO
WRITE to WRITE Delay (S): AUTO
WRITE to WRITE Delay (D): AUTO

3rd Information :

WRITE to PRE Delay: AUTO
READ to PRE Delay: AUTO
PRE to PRE Delay: AUTO
ALL PRE to ACT Delay: AUTO
ALL PRE to REF Delay: AUTO
DRAM Static Read Control: Disabled
DRAM Read Training: AUTO
MEM. OC Charger: AUTO
AI Clock Twister: AUTO
AI Transaction Booster: AUTO
Common Performance Level [5]
Pull-In of CHA PH1: DISABLED
Pull-In of CHA PH2: DISABLED
Pull-In of CHA PH3: DISABLED
Pull-In of CHA PH4: DISABLED
Pull-In of CHB PH1: DISABLED
Pull-In of CHB PH2: DISABLED
Pull-In of CHB PH3: DISABLED
Pull-In of CHB PH4: DISABLED

CPU Voltage: 1.4
CPU GTL Voltage Reference (0/2): AUTO
CPU GTL Voltage Reference (1/3): AUTO
CPU PLL Voltage:1.6
FSB Termination Voltage: 1.26
DRAM Voltage: 2.2
NB Voltage: 1.3
NB GTL Reference: AUTO
SBridge Voltage: AUTO
PCIE SATA Voltage: AUTO

Load Line Calibration: ENABLED
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : AUTO
NB Clock Skew : AUTO

Advance CPU Settings
ALL DISABLED
NB Voltage is way high mate, PLL 1.9 are you mad ? FSB Term on AUTO = way overkill... try my above settings first... see if you can get her stable at 4Ghz with 500FSB... How much volt you will need for ya CPU is CPU dependant... but 1.4 should be easily doable... if it posts and gets into windows yet craps out after some time it might be required to tweak the GTL's...once you get it stable try to go lower on PLL voltage and Vcore... then NB voltage (I can do 500FSB at 1.26Nb voltage with 4gb of ram)

If it's stable try to get the ram up to 1200Mhz, note that the rams are overvolted... 2.2 is around 2.28 actually... with 500FSB/1000Mhz ram PL 10 is possible, with 500FSB and 1200Mhz ram PL 8 might be possible... all depending on ya rams and other hardware... Clock twister and co can also be boosted but try to get 500FSB first...

Good bios is 1103 for me, no issues (till now)

Keep us posted what gives...