Quote Originally Posted by NBF View Post
I have same fsb with 803 and 1102 BIOSes

Most of the settings were on Auto in my 500+fsb runs!

The ones that I mannualy set are the following

CPU Ratio Setting: 7
FSB Strap to North Bridge: 333
FSB Frequency: 500
PCI-E Frequency: 101
DRAM Frequency: 1000

DRAM Timing Control: Manual
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15

AI Transaction Booster: MANUAL
Performance Level: 10
Pull-In of CHA PH1: DISABLED
Pull-In of CHA PH2: DISABLED
Pull-In of CHA PH3: DISABLED
Pull-In of CHA PH4: DISABLED
Pull-In of CHB PH1: DISABLED
Pull-In of CHB PH2: DISABLED
Pull-In of CHB PH3: DISABLED
Pull-In of CHB PH4: DISABLED

CPU Voltage: 1.500
DRAM Voltage: 2.02
NB Voltage: 1.5 (probably can be much lower, but I didn't try)

Load Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Margin Enhancement : Optimized

Advance CPU Settings
All settings: Disabled
NBF, I'm trying your settings with my Q6600 (G0) and P5Q-E (1101 beta bios). I found I couldn't boot into Vista 64 without keeping VCore and NBCore close to 1.50 V like you. However my system isn't Prime95 stable, keeps freezing after a couple minutes, so I'm progressively dialing down my FSB frequency. I'm down to 494x7 right now, but my temps are hovering around 71-72°C. I think that's the max recommended temp for my chip according to Intel. Should I be worried at all?