Quote Originally Posted by wongnog View Post
Hmmm well I never went down to the 6x multiplier. I guess high fsb trumps high clock speed in all cases? Please post your bios settings, also which bios are you using? Oh ya and I have 2x2gb PC2-8000 (OCZ Platinum XTC), but one of my sticks is bad so I have to get it RMA'd.
I have same fsb with 803 and 1102 BIOSes

Most of the settings were on Auto in my 500+fsb runs!

The ones that I mannualy set are the following

CPU Ratio Setting: 7
FSB Strap to North Bridge: 333
FSB Frequency: 500
PCI-E Frequency: 101
DRAM Frequency: 1000

DRAM Timing Control: Manual
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15

AI Transaction Booster: MANUAL
Performance Level: 10
Pull-In of CHA PH1: DISABLED
Pull-In of CHA PH2: DISABLED
Pull-In of CHA PH3: DISABLED
Pull-In of CHA PH4: DISABLED
Pull-In of CHB PH1: DISABLED
Pull-In of CHB PH2: DISABLED
Pull-In of CHB PH3: DISABLED
Pull-In of CHB PH4: DISABLED

CPU Voltage: 1.500
DRAM Voltage: 2.02
NB Voltage: 1.5 (probably can be much lower, but I didn't try)

Load Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Margin Enhancement : Optimized

Advance CPU Settings
All settings: Disabled