Apogee GTZ

[jonny_ftm]

Sure, Not sure I'll get them all done, but I should have the following I'll be working on:

• Apogee GTZ
• Apogee GT
• Apogee Drive
• Danger Den MC-TDX
• Danger Den TDX
• D-Tek Fuzion V1
• D-Tek Fuzion V2
• XSPC Edge Acrylic
• EK Supreme
• Aqua Computers Double Impact
• Thermalright XWB-01

But I'm not rushing this, going to take my time and do the full 5 mount detailed testing and some of them I might test with different nozzles, etc.

I'm also going to setup my flow meter in the test loop to record actual flow rate (Not completely necessary, but why not make use of it), going to run straight water, and I'm going to spend some time prior getting the actual heat load in watts of my processor so I can generate c/w values and maybe even play with the OC to determine the heat load at different overclocks.

Should be good I hope to maybe take the estimators a step further.

I've even been pondering running more than one pump scenario, perhaps one and then two DDCs with tops just to iron out if extra pumping power does anything or not.

That's a really huge project. It's great to know you'll be back soon. Also, you'll be the first one publishing full results of a comparision between EK Supreme, the Fuzion v2 at stock and the new GTZ on a quadcore.

I suppose here you're going the Q6600 route?

By the way, just about all this funding discussion... I just realised there was a donation way to martin's on the flow estimator page. I just sent a small contribution for his valuable work. I think it's the way to go. If everyone using his tools/articles would contribute, independent reviewers would live. But I know, it's far from being a perfect world

Any chance you can test the Enzotech SWC-Rev. A?
http://www.enzotechnology.com/scw_reva.htm

It would be great, even if I won't miss it. On the italian tests published in another post, the top revision yielded worst performance on a quadcore