**Official DFI LanParty UT X48-T2R(and LT) Discussion

[zfactor]

u need to have like 1.45V on the NB and 1.8x on the SB

and set the PL adn mhc delay to 8 (in the ram timings)

okay tried these settings and again c1 error.. no go. reset and now is fine at all auto but i cant seem to set them manually??

for the cpu jumpers on the mobo do you normally set them for auto or set them for what the fsb is of the cpu i am being told mixed on that from different people, some are telling me to leave it on auto and some say i need to set it for the actual fsb of the e8500.. which is better

also i ran orthos and i get a fail test on number 5... i have not run memtest yet.. anything else to try??

very new to dfi and the bios is def a bit overwhelming right now.. thanks for any help..

[Praz]

for the cpu jumpers on the mobo do you normally set them for auto or set them for what the fsb is of the cpu i am being told mixed on that from different people, some are telling me to leave it on auto and some say i need to set it for the actual fsb of the e8500.. which is better

There would be no benefit of setting the BSEL manually with the jumpers vs letting the board do it.