**Official DFI LanParty UT X48-T2R(and LT) Discussion

[zanzabar]

zfactor i would disable the j micron and just use the intel raid drivers as i use that to run all my hdd`s and dvd/cd drive. I dont see any reason to use both controller`s if your using sata connections for your dvd drive.

u cant use raid and boot a non raid device from the intel controller (so no sata dvd booting) and u cant use the pata without the jmicron enabled

[SimpleTECH]

AriciU, did you install the FDD power near the x16 PCI-e slots?

[wilson]

u cant use raid and boot a non raid device from the intel controller (so no sata dvd booting) and u cant use the pata without the jmicron enabled

I have j-micron disabled and have the intel raid driver installed only and on sata ports 1 2 and 3 i have my hdd`s and in port 4 and 5 i have my dvd and cd drive. So should i not be doing this as all i have enabled in the bios is raid ?

[KingOfToasty]

Does anyone know where I might find a listing of what all the error codes on the LED display mean? It would help me a lot with overclocking if I knew exactly which messages meant what.

[SimpleTECH]

Does anyone know where I might find a listing of what all the error codes on the LED display mean? It would help me a lot with overclocking if I knew exactly which messages meant what.

They can be found here: http://www.clunk.org.uk/forums/hardw...herboards.html

This site explains everything regarding the x48 board. I highly recommend you check the rest out.