Project: Queso - MM Ascension 3 WC Loops

[Astratuner]

Perhaps got a pic of those screws

Those screws go all the way through your rad? Or just to the first opening cause i know from the warnings that you can damage your rad if your not carefull enough

You have chosen for the most powerfull pumps that you could get from Laing right? If the more always the better? More flow i think, but then the water can't take mutch heat or dispence more heat ot the rad if you over do it not? Then you have to stick with 1/2" tygon right cause of the pump things are 1/2"?

Is 1/2" better for performance wise then 3/8"?

Also you just drilled holes into the bottom of the case to mount the pumps???

I've read that you can change the 'flow' speeds on those pumps? So you regulate the voltage they get and that changes the speed iirc?

This might be because i'm still green behind my ears and watercooling is a new thing for me

Also the pumps how are they all connected? And is there a way to monitor them? Cause I can't imagine that when you boot you have to check your pumps etc

Does you rig has a fancontroller or you didn't pick one ? If you have one you made pairs out of 2 fans for connecting it onto the controller?


I know it's alot But much appreciated

Thanks