Quote Originally Posted by Telo View Post
Sashin, just like I advised Flanr, try not to use those Anandtech settings. I think they were used for a higher RAM clock, because even the AUTO settings are tighter than them. I have tighter timings and settings going at 1900Mhz than you do at 1600Mhz, meaning something is not right there.

Try to lower your PLL back to 1.50v. Furthermore, that CPU voltage, do you seriously require 1.50v? I know it is a QX and everything but that can kill it really soon. Your FSB is a mere 400Mhz and I know you got the 10x multi in effect, but your voltage shouldn't really be that high; if I were you I would try to keep it under 1.3625v. Do me a favor try these:

vCore 1.3625v
vDIMM 1.84v
vNB 1.30v - 1.40v
vSB 1.388v
PLL 15088v
VTT 1.25v [real]

Try to get rid of all those custom Anandtech settings, specially the GTL settings and set them all at AUTO. Let us know what happens.
MY PC is down at the moment since this damn 30" won't show the BIOS screen so I got to get me a double head DVI cable to send the BIOS screen to my previous 20" monitor [temporarily]; but once I do I can upload a picture of the settings. If you would like, I do have one, but it was saved at the highest quality [1,005Kb so it cannot be uploaded to the forum] I can email it to you; just PM me an email address.

Telo, just tried the settings you gave me and at memory timings on auto, and reduced NB and DRAM voltage and cpu GTL settings at default... the system will not post and i get LCD error 01 all the time . i have even reset and turned of the main power ...but always the same NOT able to post. I did leave the cpu voltage at 1.50.
I then tried to leave all on auto except control dll, command dll and clock dll at -2 and everything else on auto...again the system will not post. Then i did as above BUT left tRTRS, tRTRD, tWTRS, tWTRD at 6C 8C 3C 6C and the rest on auto....system boots up ...very very slow to do just about anything...clicking to run any programs is very very slow..i have not even tried to run any benchmarks as the whole system is very sluggish..
So in other words Telo, the auto settings are no good for quads on this mobo. Anyone else using Cellshocks and this mobo with a quadcore...please feel free to comment.
Regards
sashin