Foxconn Quantum Force Black Ops X48 OC Guide (56k Warning)

[Telo]

Thanks for the info Telo, LardArse and flanr. After getting input from youorselves and Anandtech settings. I have been able to run 3DMark 06 and 3DMark Vantage with success so far. See pics attached. I do not know if these results are repeatable and i have yet to run Super Pi, Prime 95 , Everest Benchmark Test or Custom PC 2007 Benchamark Suite. These results were obtained with Antivurus running in the background (ie NOT disabled with full internet connection). My with Ageia panel showing 58 celcius on full load and NB temp are 42 full load (while running 3DMark Vantage CPU test)

Sashin, just like I advised Flanr, try not to use those Anandtech settings. I think they were used for a higher RAM clock, because even the AUTO settings are tighter than them. I have tighter timings and settings going at 1900Mhz than you do at 1600Mhz, meaning something is not right there.

Try to lower your PLL back to 1.50v. Furthermore, that CPU voltage, do you seriously require 1.50v? I know it is a QX and everything but that can kill it really soon. Your FSB is a mere 400Mhz and I know you got the 10x multi in effect, but your voltage shouldn't really be that high; if I were you I would try to keep it under 1.3625v. Do me a favor try these:

vCore 1.3625v
vDIMM 1.84v
vNB 1.30v - 1.40v
vSB 1.388v
PLL 15088v
VTT 1.25v [real]

Try to get rid of all those custom Anandtech settings, specially the GTL settings and set them all at AUTO. Let us know what happens.
MY PC is down at the moment since this damn 30" won't show the BIOS screen so I got to get me a double head DVI cable to send the BIOS screen to my previous 20" monitor [temporarily]; but once I do I can upload a picture of the settings. If you would like, I do have one, but it was saved at the highest quality [1,005Kb so it cannot be uploaded to the forum] I can email it to you; just PM me an email address.