Quote Originally Posted by spikerules View Post
If someone could try out some OCZ ReaperX memory (2x 2GB) with bios G25, I would be much appreciated. I cant get ANY memory overclocks done with this board. In fact, the board is actually running the memory SLOWER than it should, and whenever I try to get it to 1333 (which is what the memory should run at) the power shuts off and then it wont run again until I reset the board! Its becoming REALLY annoying. I also have an issue where CPUZ is telling me I am running at 2.4... but when I put some load on the CPU it goes up to 3.6! I have turned speedstep off in the bios, so why is this happening?
Disable everything in the CPU Config except for the Core Multi Processing. That will take care of the CPU throttling. As far as the memory. Switch the board to Manual OC mode. Set the memory voltage to the voltage as close to 1.85V as possible. You might hafta go to like 1.91. Then set the memory timings to 6-5-5-18-1T. If thats unstable you might need to loosen the timings try like 7-7-7-18-1T. You might need to try using some of the different memory dividers.