Official GIGABYTE X38-DQ6/X38T-DQ6 Info/BIOS Thread

[TyphooN]

Robust Graphics Booster: AUTO
CPU Clock Ratio: 9X
CPU Host Clock Control: Enabled
CPU Host Frequency(Mhz) : 412
PCI Express Frequency (Mhz) : 100
C.I.A.2 Disabled
Performance Enhance :Extreme
System Memory Multiplier (SPD) 2.40B
Memory Frequency(Mhz):989(501MHz in memset? o.O)
DRAM Timing Selectable :Manual
Standard Timing Control
CAS Latency Time: :5
DRAM RAS# to CAS# :5
DRAM RAS# Precharge :3
Precharge Delay(tRAS) :13
Advanced Timing Control
ACT to ACT Delay(tRRD) :2
Rank Write to READ Delay :3
Write To Precharge Delay :3
Refresh to ACT Delay :43
Read To Precharge Delay :1
tRD :7
tRD Phase Adjustment :13
Command to #CS Timing: : 2T
Clock Driving and Skew Control
CPU/PCIEX Clock Driving Control : 800mv
CPU Clock Skew Control :Normal
(G)MCH Clock Skew Control :Normal
System Voltage Control
DDR2 OverVoltage Control :+0.25v
PCI-E OverVoltage Control :Normal
FSB OverVoltage Control :+0.15v
(G)MCH OverVoltage Control :+0.15v
Loadline Calibration: Enabled
CPU Voltage Control: 1.54375V

CPU is a Q6600, Memory is G.Skill PC8000 2x2gb. I thought that I had it stable with the 2.66D strap with these settings but I could not make it 100% stable, which isn't good enough for me for a 24/7 setting. Richard try out these timings as they are as tweaked as I can get them for this speed.