Quote Originally Posted by MoogyMonster View Post
Wonderful Anuaja! What about your other voltages, such as SB, etc?

Also your memory MHz, timings, etc?

Is this stable 24/7? That's what I'm looking for...

Thanks!
Try this,

Overclock Tuner : Manual
OC From CPU Level Up : Auto
CPU Ratio Setting : 9
FSB Frequency : 445
FSB Strap to North Bridge : 400
PCI-E Frequency: 105
DRAM Frequency: DDR2-1186
DRAM Command Rate : 2T
DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 10
RAS# to RAS# Delay : 3
Row Refresh Cycle Time : 30
Write Recovery Time : 4
Read to Precharge Time : 3

Read to Write Delay (S/D) : 8
Write to Read Delay (S) : 3
Write to Read Delay (D) : 4
Read to Read Delay (S) : 4
Read to Read Delay (D) : 5
Write to Write Delay (S) : 4
Write to Write Delay (D) : 5
DRAM Static Read Control: Disasbled
Ai Clock Twister : Strong
Transaction Booster : Enabled
relax level :0

CPU Voltage : 1.5500v (BIOS)
CPU PLL Voltage : 1.8v (BIOS)
North Bridge Voltage : 1.59v (BIOS)
DRAM Voltage : 2.28 (BIOS)
FSB Termination Voltage : 1.5v (BIOS)
South Bridge Voltage : 1.150v (BIOS)
Loadline Calibration : Enabled
CPU GTL Reference : 0.63
North Bridge GTL Reference : 0.67
DDR2 Channel A REF Voltage : Auto
DDR2 Channel B REF Voltage : Auto
DDR2 Controller REF Voltage : Auto
SB 1.5V Voltage : Auto

NB LED Selection : NB Volt
SB LED Selection : SB Volt
CPU LED Selection : CPU Volt
Voltiminder LED : Disabled

CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled


And CPU Configuration:
CPU Ratio Setting : 9
C1E Suppport : Disabled
CPU TM Function : Disabled
Vanderpool Technology : Disabled
Execute Disable Bit : Disabled
Max CPUID Value Limit : Disabled

My Q6600 batch L737B381, vid 1.2375