Innovation Cooling's Diamond 7 TIM test results

[tastymannatees]

One other suggestion on application. I have been doing accelerated testing with glass slides thermal cycling. In the razor blade method you can see how the bubbles are introduced into the paste. These bubbles with heat and pressure expand and are a source of failure in any grease long term. I have seen some lapse into lima bean sized holes.

When you pull the sink off to check spread and then reattach the low points on the paste (when you reassemble) can trap air and look like the razor mount. best to just follow through

That is a great spread by the way

Also note on the old mount the mirrored bare spot on both sink and IHS - Pump Out?