Quote Originally Posted by Prodigys View Post
I did the switch from P5E to Rampage yesterday, no problems at all with flashing the bios etc...
Everything works just fine, now I finally can read some voltages in windows, and a lot of ram tweaks came available in the bios, I LIKE !

Also my vdroop is lovely, I got with my Q6600 on 4Ghz idle 1.384Vcore, and load also 1.384Vcore ! Only the vdrop is 1.4000 set in bios and get 1.384, but I don't mind...

About the overvolting thing off the P5E, now I can read the voltages I can say the P5E overvolts the ram with 0.09, so if you set 2.2 you get 2.29 !

Hopes this a little bit helpfull .
Are you sure about the overvolting RAM bit? Because as far as I know, the P5E boards don't actually have a sensor to read vDIMM, which means the Rampage BIOS is probably just pulling a voltage out of it's ass

And that's some pretty decent vDrop and vDroop. I'm getting about 0.05v vDrop and another 0.05v vDroop on my P5E, which is a bit of an ass sometimes.

Quote Originally Posted by Brick_top View Post
Hi everyone, Yesterday I flashed my Asus p5e with the rampage formula bios but now when I boot I receive the message that it has detected an overheat in OPT1, if I go into the hardware monitor option in the bios I see some red numbers at 125ºC. Is there any way to flash back to my regular bios?
The Rampage boards have a couple of extra temp sensors compared to the P5E, so it's just the BIOS trying to read a temp sensor that isn't there. Simply disable that temp sensor in Hardware Monitor, and you should be fine.

Eller