**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[Ace-a-Rue]

I just got one of these boards and need help. The temps are a bit crazy under load, speedfan shows 58, realtemp 50, core temp 51, everest 65. Which one is reliable?? I always trusted core temp but it normally shows higher than speedfan. I wouldn't bother but I changed my hsf from a Zalman 9700 to thermalright 120 x, so I'm not sure of what's going on here. Plus, is there a fix to run memory at 1:1.25 w/ 4g?? If I don't run 1:1, prime fails in 30 sec. I use bios beta 16 10. I know it's been answered before but it's hard to filter in 227 pages. Thanks for the help.

on my rig, i have about 10C split between real temp2.2 and coretemp since coretemp is using TjMax of 105C and realtemp uses 95C Tjmax.

realtemp is almost the same as Uguru temp readout so i am bending in that direction.

as to P95 failure after 30 seconds in other than 1:1, that generally has to do with insufficient voltage for MCH, ICHIO and Vdimm....i would increase MCH first followed by ICHIO and then Vdimm...the 1:1.25 is a tighter latency (1066 memory strap) so more voltage is needed to provide the push through power for the data to get back and forth between L2, CPU FSB, MCH hub and ICHIO hub....one other voltage to be concerned with, although far less, is CPU VTT...i would set that in the 1.3X, low end range.

also, don't forget about CPU GTLREF...a Q6600 needs in the range of 67-69% but experiment on the lower end too since bios updates might affect that point of stability.