Quote Originally Posted by karl_eller View Post
Can someone help me with getting my 2x2Gb G.Skill PC8000 kit working on this board. I'm having hella issues trying to get it to post running close to 1000Mhz.

Currently, I've got it going at:
Q6600 3.55Ghz (390x9), 1.6v BIOS
P5E, BIOS 502
RAM: 468Mhz (5:6 devider), 5-5-5-15, all other timings Auto, 2.1v BIOS (measures the same via DMM. My board appears to be an oddity in that it doesn't seem to over-volt the RAM at all).
All other voltage Auto, PCIe and CPU spread spectrum disabled, Loadline Calibration Disabled.

So it POSTs fine on those settings, and MemTests fine, but as soon as I push it up to the 4:5 devider, it flat out refuses to POST. It won't even beep, just the fans will spin, HDDs and optical drives start to spin up, then nothing. Tried different slots and different RAM order, and even just one stick, still nothing.

So what am I missing? The fact that it'll run just fine and dandy on the 5:6 divider makes me pretty sure that it's not dud RAM, but what could it be?

I tried lowtcell's settings above (or as near as I could figure comparing his MemSet to the BIOS options), and still nada.

Eller
Karl, drop your multi to 8, and push the fsb up to like 451-461, i am running 8gb of the Gskill/1000, and have mine set daily at the 5/6 divider, runnin the ram a bit over 1100, think its like 1108 or so, you wont need 1.6 for your proc either, or at least mine didnt, use 1.575/1.50, and 1.5 on cpu pll, try 1.55/57 on the norhtbridge, gtl settings at .60 cpu/.56 northbridge...

Hope this helps, also remember that the GTL volts should be amost 20% of whatever you have cpu/norhtbridge set to, or that is at least how i read into it...