Here's my settings for the E8400 on air ( please don't copy the Vcore) :
Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Control : Manual
- Ratio CMOS Setting : 09.0
FSB Frequency : 535MHz
FSB Strap to North Bridge : 333
PCI-E Frequency: 110
DRAM Frequency: DDR3- ???
DRAM Command Rate : Auto
DRAM Timing Control: Manual
CAS# Latency : 7
RAS# to CAS# Delay : 6
RAS# Precharge : 5
RAS# ActivateTime : 48
RAS# to RAS# Delay : Auto
Row Refresh Cycle Time : Auto
Write Recovery Time : Auto
Read to Precharge Time : Auto
Read to Write Delay (S/D) : Auto
Write to Read Delay (S) : Auto
Write to Read Delay (D) : Auto
Read to Read Delay (S) : Auto
Read to Read Delay (D) : Auto
Write to Write Delay (S) : Auto
Write to Write Delay (D) : Auto
DRAM Static Read Control: Disable
DRAM Dynamic Write Control : Disable
Ai Clock Twister : Enabled
Transaction Booster : 3
CPU Voltage : 1.85
CPU PLL Voltage : 1.72
North Bridge Voltage : 1.87
DRAM Voltage : 2.0
FSB Termination Voltage : 1.68
South Bridge Voltage : 1.175
Loadline Calibration : Enabled
CPU GTL Reference : 0.63x
North Bridge GTL Reference : 0.67x
DDR3 Channel A REF Voltage : Ref
DDR3 Channel B REF Voltage : Ref
DDR3 Controller REF Voltage : Ref
SB 1.5V Voltage : 1.6
NB LED Selection : NB Volt
SB LED Selection : SB Volt
CPU LED Selection : CPU VOlt
Voltiminder LED : Disabled
CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled
Advanced CPU Configuration
CPU Ratio Control : Manual
- Ratio CMOS Setting : 09.0
C1E Suppport : Disabled
CPU TM Function : Disabled
Vanderpool Technology : Disabled
Execute Disable Bit : Disabled
Max CPUID Value Limit : Disabled
Metro.cl- the key value for me to get the FSB going were both Nothbridge and Vfsb voltages. Obviously with the E8400 we're running into 2 walls - the CPUs and the Mobos FSB. I tried the E8400 on phase only managed to get up to about 555 FSB not sure if it was the CPU or the mobo - probaby both. Vpll had hardly any impact for me - 2V+ only did harm.
Reply With Quote
Bookmarks